If you have been told you need spinal decompression, you may have noticed it is offered two very different ways. Some providers decompress the spine by hand. Others use a computer-controlled table.
Both aim to take pressure off a bulging or herniated disc and the nerves around it, but how they deliver that relief, and how consistently, is not the same.
At The Disc Chiropractic in Wheat Ridge, we use both hands-on care and the Triton DTS decompression table. Here is how the two approaches compare, and what the research says about each.
What Spinal Decompression Is Trying to Do
Your spinal discs sit between the vertebrae like cushions. When a disc bulges or herniates, it can press on a nerve root and cause back pain, leg pain, numbness, or weakness.
Decompression gently stretches the spine to separate the vertebrae. That lowers the pressure inside the disc and widens the space where nerves exit. In one randomized trial of 60 patients, herniated discs shrank by an average of 27.6% on MRI with decompression, compared with 7.1% without it.
The question is how that stretch is applied.
Manual Spinal Decompression: Hands-On Traction
In manual decompression, a chiropractor or therapist applies the stretch with their hands. Common techniques include:
- Manual traction: the clinician gently pulls along the length of the spine, often at the legs or pelvis for the low back, or at the base of the skull for the neck.
- Flexion-distraction: the patient lies face down on a special table while the practitioner gently flexes the spine and applies a pulling force by hand.
- Mobilization with distraction: slow, rhythmic movements combined with light traction to open specific joints.
What the Research Shows for Manual Decompression
Manual techniques do have research support. In a randomized trial of 30 patients with lumbar radiculopathy, manual lumbar decompression reduced pain and improved range of motion and function, with the strongest results in patients whose symptoms were recent.
Another trial found that both manual traction and intermittent mechanical traction improved muscle strength and reduced disc herniation in patients with an L4-L5 herniated disc.
Where Manual Decompression Falls Short
The limits are mostly practical:
- Force is hard to measure. A clinician cannot know exactly how many pounds of pull they are applying.
- It is hard to sustain. Holding a steady stretch for 20 minutes or more is not realistic by hand.
- It varies. Force and angle change slightly from session to session and from clinician to clinician.
- It is hard to target. Aiming the stretch at one specific disc level takes precise positioning that is difficult to repeat.
Table Spinal Decompression: Computer-Controlled Precision
A decompression table uses a motor and software to apply the stretch. You lie on the table in a harness, and the system delivers a programmed protocol of pull, hold, and gradual release cycles.
At our Wheat Ridge office, we use the Triton DTS. Before each session, we set:
- Force: measured precisely, up to 200 lbs of pull
- Angle: adjusted to target a specific disc level
- Timing: hold and relaxation cycles that ease the spine into and out of each stretch
- Duration: a sustained session, typically 20 minutes or more
Because the table delivers the same protocol every visit, we can track your response and adjust one variable at a time.
What the Research Shows for Table Decompression
Computer-controlled decompression has a growing body of supportive research:
- In a randomized trial of 60 patients with herniated discs, pain scores finished at 2.0 with decompression versus 3.9 with conventional traction, and straight leg raise improved to 79 degrees versus 63 degrees.
- In a trial of 31 patients, disc herniation size decreased significantly more with decompression than with conventional traction.
- In a study of 30 patients, low back pain dropped from 6.2 to 1.6 out of 10 while disc height increased from 7.5 mm to 8.8 mm over a 6-week decompression program.
- In a randomized trial of 31 people, pain dropped 4.75 points with decompression plus core exercises, versus 2.60 points with exercise alone.
Manual vs. Table Decompression: Side by Side
| Manual decompression | Table decompression (Triton DTS) | |
| How the stretch is applied | By the clinician’s hands | By a computer-controlled motor |
| Force | Estimated, limited by clinician strength | Precisely set and measured, up to 200 lbs |
| Targeting | Approximate | Angle programmed to a specific disc level |
| Session length | A few minutes | Sustained, often 20 minutes or more |
| Consistency | Varies by session and clinician | Same protocol every visit |
| Best suited for | Acute pain, joint stiffness, patients who prefer hands-on care | Disc herniations and bulges, sciatica, nerve compression |
In one comparison, patients treated with intermittent mechanical traction improved more than those treated with manual traction.
Which Is Right for You?
For most disc-related pain, the answer is not either-or. Manual techniques are excellent for restoring joint motion and easing muscle guarding.
Table decompression delivers a precise, sustained, repeatable stretch to the disc itself.
That is why our plans combine both: Gonstead and CBP chiropractic adjustments and soft tissue therapy for the joints and muscles, spinal decompression on the Triton DTS for the disc, and therapeutic exercise to keep the results.
Find out if table decompression is right for you. Book your $97 first visit at The Disc Chiropractic in Wheat Ridge. Call (720) 573-4910.
Frequently Asked Questions
Is manual spinal decompression as effective as a decompression table?
Both can help, but they suit different goals. Manual techniques work well for joint stiffness and acute pain. For disc herniations and sciatica, a table delivers a measured, sustained stretch that is hard to match by hand, and computer-controlled decompression outperformed conventional traction in two randomized trials.
Does table decompression hurt more than manual decompression?
No. Table decompression eases into and out of each stretch gradually, and most patients find it relaxing. Many fall asleep during sessions.
Can I do spinal decompression at home?
Inversion tables and home traction devices provide a general stretch, but they cannot target a specific disc level or control force precisely. If you have a diagnosed disc problem, get evaluated before trying home traction.
How many table decompression sessions will I need?
A typical plan at our clinic runs 12 to 24 sessions, combined with adjustments and core exercises. We adjust the plan based on how you respond.
Who should not have spinal decompression?
Decompression is generally not recommended with a recent spinal fracture, significant osteoporosis, spinal fusion or hardware in the treatment area, spinal tumors or infections, pregnancy, or an abdominal aortic aneurysm. We screen for these at your first visit.
